Cast Iron baseboard on a Steam System

 
Piping steam cast iron baseboard into a steam system can be a bit tricky. Copper tubing is not recommended for steam applications due to high heat loss through the tubing and thermal expansion noise. Maximum recommended length for steam applications should be limited to 10 lineal feet. Use of PTFE (Teflon®) tape or paste containing PTFE is not recommended as over tightening is possible, causing cracking of the Base Ray tapping's. It is not recommended that cast iron baseboard be used in a One-Pipe Steam System.  Two-Pipe Steam or Vapor Systems are steam systems in which each cast iron baseboard assembly is provided with two piping connections, and where steam and condensate flow in separate mains and branches. The vapor system differs from the low pressure system only in the type of air valve used. So the trick here is to convert the baseboard to a two pipe application even if the system is one pipe. This can be accomplished a few different ways as shown in the drawings below.
 
The baseboard will need to be pitched toward return tapping's. The pitch for a 10' piece of baseboard would be about 1-1/2" low side being the return piping end.
 
The key is to keep the live steam from entering the return be it wet or dry returns see the comments below.
 
 
Drawing #1

If the installation will require piping the baseboard to a dry return you could use a steam trap on the end of the radiation. The trap will allow air to pass through but when steam gets into the trap the trap will close. When enough condensate accumulates in the trap it will cool approximately 10f and the trap will re-open to allow the condensate to exit the trap and close again when the live steam enters the trap.  An air vent on the radiation would not be required. Another option is explained below. A few installers have had issues with water from the vent with this installation but most have worked well. The few with issues I believe were operating above 2 psi which is the max pressure on residential systems. 

 

 

 

Drawing #2

 

If you do not want to use a mechanical trap on the return side of the baseboard and you have the room you could create a water seal between the baseboard and the dry return with a trap. Steam will not get into the return as it cannot get trough the water trap. Pipe the return side below the dry return and back up to create the required water seal. The water seal must drop 30" per pound of steam pressure below the return connection point.

 

 

Drawing #3

 

This is the same as above but the wet seal is returning back to the steam main. I prefer this drawing less than the above drawing as much more water ends up in the steam main possibly causing water hammer noises in the system.

 

 

 

Drawing #4

  

In this last drawing you would be piping the return side of the cast iron baseboard into a wet return verifying the connection will always be below the water level of the steam system. Since water will seek it's own level, the water in the system piping will be equal to the water level in the boiler.

 

 Disclaimer: The information found on this website is for informational purposes only. Any and all preventive maintenance, service, installations should be reviewed on a per job situation. Any work performed on your heating system should be performed by qualified and experienced personnel only. Comfort-Calc or it's personnel accepts no responsibility for improper information, application, damage to property or bodily injury from applied information found on this web site as it should be reviewed by a professional.